Your gas testing and monitoring equipment need to be regularly calibrated and tested, and this can only be done with properly mixed calibration gases.  There a hundreds of types of gases available, any only a small subsection of those gases are listed below.  Please contact the knowledgeable staff at Hawk Equipment Services for a formal quote on the gases that you may need for your units.  We would be happy to walk you through the process and do the research to make sure that you are getting the best possible solution at the best possible price.

We offer the following Fixed Gas Detection Sensors Services:

Commissioning

Fixed gas detection systems are a common part of the construction process when building a new warehouse, parking garage, manufacturing facility, water treatment pant, municipal building, and many other types of commercial spaces.  These systems are often installed and designed by the general mechanical contractor, but frequently the final startup and commissioning is left to the owner or contractor.  Hawk Equipment Services offers a full service third-party commissioning service for fixed gas detection systems.
Our commissioning services for fixed gas detection systems provide a way for building owners, mechanical contractors, and inspectors to be sure that their new sensor net is functioning as designed.  Our trained techs will perform and document the following:

  1. Document and confirm how many sensors are installed, where are they located, and that they are showing active on the building control system interface panel
  2. Document the serial numbers and factory calibration dates
  3. Bump test each sensor and document the response on the building control system interface panel
  4. Create a formal commissioning report for the sensor system including all of the collected data, NIST traceable gas lot numbers, accurate sensor responses, and next due date for calibration

Onsite Calibration

Our team of experts at Hawk Equipment is happy to help with all of your onsite calibration needs. Our team can help calibrate your sensors to ensure your health and safety services are functioning properly and protecting your employees. We can help you record and document calibration, affix a calibration label to the unit, and create and deliver a calibration sheet for all sensors serviced.

Sensor Replacement

Fixed gas detection systems will require sensor replacement from time to time. Our team is happy to assist you in this process, and insure that your sensors are properly installed and functioning to keep your team safe.

Repair & Troubleshooting

If your fixed gas detection systems are malfunctioning, we’re here to help. The Hawk Equipment team is well versed in repair and troubleshooting, and can make sure your fixed gas detection systems are up and running and your team is taken care of.

Hawk Equipment Services works with these manufacturers on a regular basis:

Scott